Wednesday, November 27, 2019

Senior Design Project - Post 2.

Last Friday we did our proposal presentation and I think I did well. We were told that our presentation was really good, but a little bit short. We still have not got our grade or feedback, but should be getting those next week.

Last night I finished assembling the InMoov finger starter and tested it with the MyoWare muscle sensor. It took me a few hours to get the code right, but I got it working, as seen in the video below.



A problem I encountered was that testing the finger while connected to my laptop would shut my laptop off. I have to look up what might be the cause, but I think it may have to do with the servo drawing too much current.

No comments:

Post a Comment

Senior Design Project - Post 4.

I finished connecting the servos to the fishing lines, connected the servos to the power module, and tested the code to open and close every...