However, the leads of the tubes are too short, and I could only manage to solder one, and barely. I'll have to get more tubes in order to finish the project.
Note that I only soldered a few joints just to hold the Nixie in place.
Subscribe to:
Post Comments (Atom)
Senior Design Project - Post 4.
I finished connecting the servos to the fishing lines, connected the servos to the power module, and tested the code to open and close every...
-
Today morning I finished writing the report for my Senior Design Proposal. We have just a week before the presentation. I'm a little ne...
-
Last night I finished printing all the parts for the InMoov hand and forearm. Today I spent a few hours assembling it. Tomor... -
Last Friday we did our proposal presentation and I think I did well. We were told that our presentation was really good, but a little bit sh...
No comments:
Post a Comment