Sunday, May 20, 2018
Soldering the IN-14 board.
The flux pen worked marvels to remove the solder bridges from the SMDs and to solder them properly.
I also soldered all the pin headers and current-limiting resistors on the board.
Now I only need a few components to finish the main board, the Nixie tubes, and to do the perfboard with the dummy components and I can test if it works.
Subscribe to:
Post Comments (Atom)
Senior Design Project - Post 4.
I finished connecting the servos to the fishing lines, connected the servos to the power module, and tested the code to open and close every...
-
Today morning I finished writing the report for my Senior Design Proposal. We have just a week before the presentation. I'm a little ne...
-
Last night I finished printing all the parts for the InMoov hand and forearm. Today I spent a few hours assembling it. Tomor... -
Last Friday we did our proposal presentation and I think I did well. We were told that our presentation was really good, but a little bit sh...
Seminole Hard Rock Hotel & Casino – Hollywood, FL
ReplyDeleteFind 동두천 출장마사지 the best Seminole Hard Rock Hotel & Casino, Hollywood in 사천 출장샵 South Florida, United States of America 제주 출장마사지 at 의왕 출장샵 MapYRO. Fast 서울특별 출장샵 payouts and great rates.